|
Module manual
- Protect the contacts of module's connectors
and SD/microSD card from contamination. Any dirt and/or
fat on contacts may cause errors during programming.
- Unscrew knurled thumb screw. Properly Insert
programming module into Programmer Module Interface
connectors, until it clicks. Due to connectors
shape, only one orientation and position of
programming module in Programmer Module Interface
connectors is possible. Screw knurled thumb screw
to fix programming module to programmer.
- Insert the SD/microSD card
into the connector. Correct connector type and
orientation of the card is indicated by picture near
the card connector.
- Push the SD/microSD card
until it clicks into place.
- To take out the card, push
the SD/microSD card again to auto-eject. Attention
please, microSD card can be ejected too fast due to
strong spring force. Please hold the card during
auto-eject.
- When you finish the work
with module, unscrew knurled thumb screw and
remove the module from Programmer Module Interface
connectors.
- Operating
conditions: temperature 5°C ÷ 40°C (41°F ÷ 104°F),
humidity 20% ÷ 80% non-condensing.
Accepted package(s)
| SD
card |
 |
|
|
|
microSD card |
 |
|
|
 Back to top
The information in this document are subject to
change without notice.
|
