|
Modul manual
-
Protect the contacts of module
connectors and ZIF socket from contamination. Any
dirt and/or fat on contacts may cause errors during
programming.
Proceed with care! Incorrect
insertion of device in module ZIF socket may lead to
programmed device damage.
- Unscrew 2 knurled thumb screws. Insert
programming module into Programming Module Interface
connectors, until it clicks. Due to connectors
shape, only one orientation and position of
programming module in Programming Module Interface
connectors is possible. Screw 2 knurled thumb screws
to fix programming module to programmer.
- Push the cover of module ZIF socket (the topmost
movable part) to open the socket. Insert the device
into module ZIF socket. Correct position of
programmed device in module ZIF socket is indicated
by picture near (usually on left above) the module
ZIF socket. On that picture, reference corner of
device (e.g. position of pin 1) is indicated by dot,
by number 1, by bevelled corner or by any
combination of mentioned. Then release module ZIF
socket.
- The cover must be fully actuated
(depressed) before inserting a device into the
socket. If device is inserted into only partially
opened ZIF socket, then - after releasing of cover –
device pins might get damaged.
- Do not press on device while inserting it and/or
releasing the cover.
- Visually check the placement of programmed
device in module ZIF socket. If everything looks OK,
the device is ready for programming.
- To take out the device from module, push the
cover of module ZIF socket and remove the device.
When you finish the work with module, unscrew 2
knurled thumb screws and remove the module from
Programming Module Interface connectors.
-
For handling with the device we recommended to use a
vacuum pick up
tool.
-
Operating
conditions: temperature 5°C ÷ 40°C (41°F ÷ 104°F),
humidity 20% ÷ 80% non-condensing.
Accepted package(s)
| QFN32 |
 |
|
|
 Back to top
The information in this document are subject to
change without notice.
|
